@Gabriel C I understand the urgency of the situation. It seems like there might be an issue with the way the tool is being called by the assistant. To resolve this, we need to ensure that the tool is configured correctly and that the assistant is calling it properly. Here are a few steps you can take to troubleshoot the issue: 1. **Check the Tool Configuration**: Ensure that the tool you've added has the correct configuration that matches the expected input and output parameters of the original function. 2. **Review the Assistant's Call Logic**: Look at the logic within the assistant that is responsible for calling the tool. Make sure that it's not set up in a way that would cause it to loop indefinitely. 3. **Check for Conditional Statements**: Ensure that there are proper conditional statements in place to prevent the assistant from calling the tool repeatedly without an exit condition. 4. **Test with a Simple Scenario**: Try to create a simple scenario where the tool is called once to see if it executes correctly. This can help isolate the problem. 5. **Review Logs**: If possible, review the logs to see what is happening when the tool is called. This might give you insights into why the tool is being called repeatedly. 6. **Consult Documentation**: Double-check the documentation for any changes in the way tools should be implemented as opposed to functions. If you've gone through these steps and the issue persists, it might be necessary to get in touch with the support team for further assistance. They can provide more detailed guidance and help you resolve the issue promptly. Would you like me to guide you through any of these steps in more detail?